Messages

1

Speech Technology / Neo speech Voice

« on: October 29, 2006, 02:14:14 pm »

Found the solution. If you have bought the ultra hal with neo speech voices, like I did, you need to select 'custom' install, rather than 'typical'.

When you choose 'custom', the option to install kate and paul appears; you select them and they are then available for selection when needed.

2

Speech Technology / Neo speech Voice

« on: October 29, 2006, 04:41:16 am »

Maybe I have it confused but thought when I ordered ultra hal it came with them. On the inside of the cd it says
'after installation select neospeech paul or neospeech kate' as your voice in ultra hal tts reader.
Also the cd label says 'includes neospeech'

Plus I can see kate and paul folders have been installed.

Any further ideas appreciated.

3

Speech Technology / Neo speech Voice

« on: October 28, 2006, 04:00:37 pm »

Just rcvd ultra hal 10.27.06 and installed on win 2K laptop. Documentation shows it should have neosp[eech paul and kate but they don't show up on the list. Have read forum posts abpi hapsapi setup but that didn''t get it. I can see the kate and paul folders.

Any suggestions appreciated.