Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - DarcyEdwards

Pages: [1] 2 3 ... 13
1
Programming using the Ultra Hal Brain Editor / Re: Editing Definitions
« on: November 24, 2010, 09:59:59 am »
Hi and welcome to the forum.  Can you be a liltle more specific in what you would like to change.

2
Hi d_vyn1,

Welcome to the forum!  I would love to hear more about your ideas.

3
LS,

Been running all day without any issues, looks good[:I]

4
LS,

I downloaded it and so far no problems.

5
LS,

Type mismatches are tough to trace!  Sure I would love the latest version [:D]

6
Speech Technology / Hal Ultra Windows 7 x64 installation problem
« on: May 02, 2010, 04:50:14 pm »
I have Windows 7/64 bit.  I Have the TextToSpeech (TTS) I think you are talking about and it works ok for me, so does Hal 6.2

7
Ted,
You are very welcome and thank you for your troubleshooting [;)][;)]

8
Ted,

Some how the data base got trashed!  What you need to do re configure the plug in.

1 select General options, select brain, then select the plug in, select your paramaters, select apply changes, then apply then OK.  This should correct the database entries.  Give it a try and let me know.

Thanks [:p][:D][:D]

9
LS,

No I have not come across the error, I deleted the old unreleased uhp file.  I seen a simular error during testing, but not in the latest uhp file.  The error went away after reloading Hal, and I never seen it again.

Ted,

Thank you

10
Hi Ted,
I should have been more specfic the "HalScript.dbg" file.Can you either upload it to the forum or email the file as an attachment.

Thanks

11
Ted

can you send me that file?

12
I have used it before, just to cumberson to use on simple uhp files.  I sorta like notepad [:D]

13
LS,

No problem, what were you using to edit the uhp files?  I always use notepad.  I'm real old school, I go back to EDLIN in CP/M days LMAO

[:I]

14
LS,

To get the line counter to display, click VIEW at the top of Notepad and click on status bar, and the line numbers will appear [:I]

15
LS,

Note pad has line number and colum counter at the bottom of the page.  None of the lines have numbers on them.  That counter tells you where the cursor is at.  Its a pain but it works.

Pages: [1] 2 3 ... 13