Zabaware Support Forums

Zabaware Forums => Ultra Hal 7.0 => Topic started by: Zotero on October 12, 2013, 03:02:06 pm

Title: Change voice commands
Post by: Zotero on October 12, 2013, 03:02:06 pm

Hope these forums aren't dead,
But you know when you set Hal to listen to voice commands on all the time, you can say "wake up computer" to open his dialog box by voice. I was wondering if there's ANY way to change that to, for example, "Hal, On."
Thanks!
-Zotero

Title: Re: Change voice commands
Post by: Art on October 14, 2013, 04:52:21 am

These commands are most likely embedded or 'hard coded' into Hal.

Perhaps Robert will chime in for assistance or you can locate him in the Members section
and drop him an email (Robert Medeksza).

Title: Re: Change voice commands
Post by: Medeksza on October 14, 2013, 09:05:02 am

Those commands are currently hard coded into Hal. I could make it an option in the next release.

Actually, the current behavior is it should respond to either "Wake up computer" or "Wake up [HalName]" where [HalName] is whatever name you gave Hal, so it is partially customizable that way.