Show Posts
1
Ultra Hal 7.0 / Cannot install. "happlayer41139.exe" error
« on: August 07, 2011, 10:42:13 pm »
Hi, I have windows XP and keep getting this error message. "happlayer41139.exe - Application error. The instruction at "0x7712153d" referenced memory at "0x77c623d8". The memory could not be 'read' ".
Installation runs fine right until this part:
Installing Animated characters
Execute: c/DOCUME~1/ADMIN~1/LOCALS~1/TEMP/happlayer41139.exe / S
Then it just says the error referenced memory happlayer41139.exe message I listed above, then it says click OK to terminate program.
After I hit OK, it just continues to install like nothing happened. Problem is once it finishes installing, the program hardly works. It closes 90% of the time by itself after I say one word to it, or it comes up with error messages. So it's basically useless. I'm guessing because it wasnt able to read that "happlayer41139.exe" file during installation that it's causing it not to work.
I tried unstalling, reinstalling, no luck. Tried turning off firewall/virus protection before installing, no luck either. I also extracted the setup file and put it on the desktop so therefore i could right click on it and go "run as administrator" but I still get the same error message. Any ideas?
Installation runs fine right until this part:
Installing Animated characters
Execute: c/DOCUME~1/ADMIN~1/LOCALS~1/TEMP/happlayer41139.exe / S
Then it just says the error referenced memory happlayer41139.exe message I listed above, then it says click OK to terminate program.
After I hit OK, it just continues to install like nothing happened. Problem is once it finishes installing, the program hardly works. It closes 90% of the time by itself after I say one word to it, or it comes up with error messages. So it's basically useless. I'm guessing because it wasnt able to read that "happlayer41139.exe" file during installation that it's causing it not to work.
I tried unstalling, reinstalling, no luck. Tried turning off firewall/virus protection before installing, no luck either. I also extracted the setup file and put it on the desktop so therefore i could right click on it and go "run as administrator" but I still get the same error message. Any ideas?