Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - MacGyver

Pages: [1]
1
Ultra Hal 7.0 / Ultra Hal Plug-in Installer Error 53
« on: December 12, 2005, 12:56:28 pm »
Good Day,
During installation of a different application (FTP Explorer app), the Ultra Hal Plug-in Installer is triggered and runs, "Installing Plugins..."; Then I get the Ultra Hal Plug-in Installer Error popup with the following:

Error 53: File not found Occured at line 8 in Ultral Hal Plug-in Installer:Form1.Form_Load

(I press IGNORE, as RETRY presents the same popup, while ABORT closes the activity)
Error 52: Bad file name or number Occured at line 9 in Ultra Hal Plug-in Installer:Form1.Form_Load

(I press IGNORE)
Error 52: Bad file name or number Occured at line 10 in Ultra Hal Plug-in Installer:Form1.Form_Load

(I press IGNORE)
Error 52: Bad file name or number Occured at line 10 in Ultra Hal Plug-in Installer:Form1.Form_Load

(I press IGNORE)
Error 52: Bad file name or number Occured at line 12 in Ultra Hal Plug-in Installer:Form1.Form_Load

(I press IGNORE)
Error 5: Invalid procedure call or argument Occured at line 12 in Ultra Hal Plug-in Installer:Form1.Form_Load

(I press IGNORE)
Error 5: Invalid procedure call or argument Occured at line 12 in Ultra Hal Plug-in Installer:Form1.Form_Load    (again)

(I press IGNORE)
Error 52: Bad file name or number Occured at line 22 in Ultra Hal Plug-in Installer:Form1.Form_Load

(I press IGNORE)
Activity closes. I'm looking back at my desktop.


So I looked in Windows (XP) Folder Options -> File Types for anuthing registered to Hal. I found 2x Haptek extensions, so I deleted them. The same senario above occurs, unchanged.

I then uninstalled Hal 6 from Control Panel->Add or Remove Programs area. The same senario above occured, unchanged.

So I rebooted (just incase). The Ultra Hal Plug-in Installer still ran (was Hal not properly uninstalled?)

Please assist... thanks!
Rick

2
Ultra Hal 7.0 / Invalid Call reading text file
« on: October 18, 2001, 04:53:38 pm »
Good day,

Using Ultra Hal Assistant v4.0.146, when I run "learn from a text file..." and select a text file (tried three: 2kb, 10kb, 7kb in size), There's always an error msgbox that pops up. The msgbox appears as it reads each line of the textfile, and is always the same.

Not sure if a file can be atached in this forum, so I'll describe the errorbox:

MsgBox title: Ultra Hal Assistant Editor
MsgBox alert is that yellow triangle with exclamation point.
and the msg is...

Error 5:
Invalid procedure call or argument
Occured at line 47
in Ultra Hal Assistant: frmLearn.Command1_Click

Buttons are Abort, Retry, Ignore.

Content of my textfiles look like this: <someword> is <the description>.

Communicating is the exchange of information.
Red zones are illegal for parking and stopping, even for only a moment.
Chocolate milk is delicious when really cold. That's why ice cream is so tasty.

Ideas?
Thanks...!
:o)
Rick

Pages: [1]