Zabaware Support Forums
Zabaware Forums => Ultra Hal 7.0 => Topic started by: markofkane on June 16, 2005, 08:55:41 am
-
But I got her to "breathe". I have only worked on it for about 30 minutes.(http://home.earthlink.net/~markofkane/breathe.gif)
-
mark great job. now we know she isnt just "laying" there! you are amazin![:X]
-
Sometimes CPR takes a while.
I'm pleased she's all right.
Carry on.
[;)]
-
lol, nice. Have you tried the 'laying down' tweak I was on about yet?
-
What tweak was that?
-
http://www.zabaware.com/forum/topic.asp?TOPIC_ID=2251&whichpage=3
bout half way down.
-
OK, where do I put those commands? Notepad? And save it as what?
A hap file? Thanks!!
-
1)Get fullbodygirl up and running and go to the hap_temp folder.
2)Find the fullBodDef.hap file and open in a text editor.
3)search for 'crouchSwitch'.
4)Make the changes to it that were in the other post.
5)Save your new fullBodDef over the old one in the hap_temp folder (as a .hap file again)
6)empty the console screen and drag the 'herStartup' hap in the hap_temp folder to get her up and running again.
7)give the console this
\SetSwitch [switch=crouchSwitch state=crouchState]
command, and she should lay down, but remain on the screen.
don't forget to keep a copy of your new figDef as it will be lost
when the hap_temp is wiped out.
It'sa bit long winded, but I think it will be down to a few commands when someone gets round to it!
-
She crouches down, but disapperars!!! [V]
I went ahead and saved all the files to my documents.
This is what I put into the figdef: (exactly as shown)
Switch= crouchSwitch
MinPeriod= -1.00
MaxPeriod= -1.00......cut......
#--STATE ID: 1--
StateProbability= 1.00
StateName= crouchState
MinPeriod= -1.00
MaxPeriod= -1.00
DecayTime= 1.00
AttackTime= 1.00
MaxAttack= 0.25......cut....
ParameterIntensity= -0.1745
Parameter= LKneeTwist
ParameterIntensity= -10.0000
Parameter= RLTranslateX
ParameterIntensity= -100.0000
Parameter= RLTranslateY
ParameterIntensity= -15.0000
Parameter= RLTranslateZ.....cut.....
StateName= cr4a
MinPeriod= -1.00
MaxPeriod= -1.00......cut....
I even tried setting all of the parameter intensities above to 0.0000
It might be easier if someone sends me the modified figfef file, and tell me which fullbody girl to use. Thanks!!
-
nightmare, sorry Mark, it's a bit of a minefield - see here :
http://www.zabaware.com/forum/topic.asp?TOPIC_ID=2305
-
Yes, those Hap files work great. How about a hap for:
1. Bending over
2. Spreading the bottom limbs.
3. squatting
And many things humans can do. I tried doing the modified figdef, but it still disappears. [V]