Zabaware Forums > Ultra Hal 7.0
Can you send command line options after Hal has started?
(1/1)
knight2000:
I would like to control Hal's mic after Hal has started up using the command line. The following code works fine if Hal is not running
"C:\Program Files (x86)\Zabaware\Ultra Hal 7\UltraHal7.exe" <SHOWHAL><MICON>"
Hal i will start with his mic enabled
However if Hal is already running he ignores any command line arguments.
Is there a way around this?
Medeksza:
Hal supports an outside program sending HalCommands using an old system called DDE ( https://en.wikipedia.org/wiki/Dynamic_Data_Exchange )
I could swear I made and posted an example of this over a decade ago on this forum, but I can't seem to find it currently.
pactive1:
See post https://www.ultrahal.com/community/index.php?topic=4101.msg22452#msg22452
Mic on, Mic off and Mic toggle
Assuming they still work
Navigation
[0] Message Index
Go to full version