Zabaware Support Forums
Zabaware Forums => Ultra Hal 7.0 => Topic started by: Derinum on March 20, 2011, 11:51:07 am
-
Basically everything is working great but when I changed from the Sandy character to the Robot and back again Sandy wont load now its just all blank I’ve tried a re set and alternative skins but to no avail.. it will load the non 3d characters fine does anyone know what I should do ?
Also is this as good as the voices get its all very r-o-b-o-t-i-c
. the programming is amazing.
:-\
-
Basically everything is working great but when I changed from the Sandy character to the Robot and back again Sandy wont load now its just all blank I’ve tried a re set and alternative skins but to no avail.. it will load the non 3d characters fine does anyone know what I should do ?
Also is this as good as the voices get its all very r-o-b-o-t-i-c
. the programming is amazing.
:-\
Hi Derinum.
you can try exiting hal the restart hal, see if it was a glitch.
good voices are pretty expensive in some cases very expensive.
Jerry
-
thanks Jerry I'll give it a try. I appreciate you taking the time to reply I was wondering if any of the 70+ viewers would pull over to help.
;)
-
I'm sure most of the 70 viewers were forum guests.
You did get an answer from the best we have. (http://i893.photobucket.com/albums/ac140/Sandee6027/Fun%20photos%201/nm11.gif)
You might go into haptek player/SAPI Config
and see what voices you have available on your computer.
Could be you simply using one of the robot voices.
-
hi Derinum
although it's easy to say don't be sorry for asking for help it's just a natural thing not to want to bother others but it's ok "we" all have and had to start somewhere and people are good on here about helping others , sometimes it takes a little bit depending on what all wwe have going on at home and with hal projects etc. so don't get discouraged . hang in their.